Markdown Export

Re-caulking a Bathtub

Copy and paste this into your website, blog, code repository, or anywhere that accepts Markdown.

# Re-caulking a Bathtub
This procedure provides a step-by-step guide on how to remove old caulk from around a bathtub and apply a fresh, waterproof seal using new caulk.

### Step 1: Preparation
Gather the necessary tools and materials including a caulk remover tool, silicone caulk, mineral spirits, a utility knife, rags, painter&#x27;s tape, and latex gloves.

### Step 2: Removal
Use the utility knife and caulk remover tool to carefully cut away and remove the old caulk from around the bathtub. Ensure all remnants of the old caulk are removed.

### Step 3: Cleaning
Clean the area with mineral spirits to remove any residue, soap scum, or mildew. Use rags to wipe down the area until it is completely dry.

### Step 4: Taping
Apply painter&#x27;s tape to the edges of both the bathtub and the wall to ensure straight lines when applying the new caulk. Leave a gap for the caulk to be applied.

### Step 5: Caulking
Cut the tip of the caulk tube at a 45-degree angle. Apply the silicone caulk into the gap between the bathtub and wall, holding the caulk gun at an angle for a smooth application.

### Step 6: Smoothing
Wet your finger and run it along the caulk line to smooth it out. This should create a clean, even seal. Ensure there are no gaps or air bubbles.

### Step 7: Finishing
Carefully remove the painter&#x27;s tape while the caulk is still wet. Be careful not to disrupt the fresh caulk. Allow the caulk to dry as per the manufacturer&#x27;s instructions before using the bathtub.

## General Notes

### Caulk Type
Ensure you use a silicone caulk suitable for bathrooms as it provides a waterproof seal and can resist mold and mildew.

### Curing Time
Do not use the bathtub immediately after caulking. Wait for the caulk to fully cure, which usually takes 24 to 48 hours.